IMORDEN Camera Slider Ball Bearing Adjustment Turtorial

When you are using a camera slider, there are the two situations you may meet:the carriage doesn't roll smooth or your camera wobbles forward and backwards(left to right) on the track.

If you happen to meet this problem, please don’t worry. It's normal for most of camera sliders as the bearings could loose in transit or after a period using.And you just need to adjust it slightly.

Here is the way to solve the problem you faced in this issue.

Tools you will need: 
2mm hex key
3mm hex key(included in the package)
Needle-nose pliers(not included, plz use your own)

1.Take your 3mm hex key and carefully loosen all 4 hex screws on the carriage. 

2.After the screws are taking out pull off the carriage to expose the bearings,take the 2mm hex key and carefully loosen each locking screw in both bearings.

3.After each screw is loose ,take your needle-nose pliers and SLIGHTLY tighten/loosen the bearings that are loose/tight.

PS:

1) Do not over tighten;

2) Take several times to test whether the carriage is properly steady/smooth or not;

3)Make sure the holes are parallel with each other after adjustment.

4.If it did, repeat previous steps to put back together.

WOW, YOU ARE GREAT! YOU'VE DONE! :)

Hope that helps!

BTW, there is the video for it on IMORDEN YouTube Channel ,you could check it out.

If you have any question or suggestion, please comment below or email us via imordencs@yahoo.com

Thanks for reading!

Lacey 

IMORDEN Customer Service